Grips would probably be pretty easy to print, but getting a model would be the difficult part. Now I need to find access to a 3D scanner...

Moderators: FergusonTO35, jeffchance, Flowmaster, 356, pockets, farmkid, adam01364, martin08, Mr Saturday Night Special
Yeah, HPs will never win a superficial beauty contest, but IMO they win the "Best bang for your buck" contest hands down. Your sleeve looks like it does the job very nicely - a better fit to the mag base and a contoured front would be icing on the cake; do that and I'll bet you could sell a pile of them over on the Hi-Point forum.Stik wrote:I printed out a few, but if I should make more I'll change the design for a better fit on the magazine base and greater rounding at the front. Seems to fit pretty well and that's what matters. If I was interested in aesthetics I wouldn't own any HPs!
Thanks, but it's a real PITA to do. Lots and lots of cutting & fitting.Stik wrote:That looks a better solution than what I did!
You just wish you were my next door neighbor.84minieldo wrote:Don't feel bad about it tho, that guy Adam got sumpin wrong wit him
Users browsing this forum: No registered users and 2 guests